Well Tempered Lab Amadeus Manual de Instruções

1 INSTRUCTION MANUAL Amadeus MK II Rev. August 2013

10 9. Correct Azimuth can be obtained by gently rotating the azimuth adjustment collar to allow the cartridge to track parallel to the record surface.

11 Stylus Pressure Gauge Fitting Batteries: When fitting the batteries in the Stylus Pressure Gauge, the positive symbol on both batteries should fac

12 Fig (17) DC Power Supply We recommend a power supply with a maximum output of 12V and not less than 7V, with a minimum of 100mA, centre pin positiv

13 Troubleshooting 1. In the unlikely event that you wish to remove the Symmetrex tonearm, the golf ball can be lifted clear of the fluid, and left

14 5. The Amadeus MK II motor has bearing tolerances that cause it to be noisy without the load of the belt and platter. It is sometimes possible duri

15 Headshell Alignment Guide For Well Tempered Turntables Note: The Headshell is factory fixed in position. Well Tempered Lab unoquivocally reiterate

16 WARRANTY & SERVICE Valid on completion of warranty card and confirmed date or purchase. Details can be registered at www.welltemperedlab.net

2 Preliminary Before embarking on the relatively simple process of assembling the Amadeus MK II, please take the time to fully read these instruction

3 Unpacking the Amadeus MK II We recommend the use of the white gloves provided when handling the plinth and platter assemblies. Take care that none

4 3. Install tonearm rest / lock in plinth approx 50mm (2in). See Fig (3) Fig (3) Suspending the Symmetrex Tonearm Before embarking on this procedure

5 3. Correct bridle length when tonearm is suspended is approximately 25mm from top of tonearm to bottom of suspension rod. See Fig (6). Apply a clock

6 5. Adjust pillar, rod and azimuth collar to allow golf ball to float central of bearing cup. Note: All the above adjustments can be fine tuned whe

7 Installing the Platter Please ensure that the point of the triangle hold in the upper teflon bearing is correctly orientated to the motor pulley.

8 Speed Control Speed change is effected by manual movement of the belt on the pulley. 33.5 RPM on the small diameter step on the pulley, 45 RPM on t

9 Fitting the Cartridge and Symmetrex Tonearm adjustments 1. We recommend fitting the cartridge with the tone arm in position. However it is possible